Classic Flame 36EB110-GRT Instruction Manual download pdf (Page 6)

Section 1: Framing

Framing Specification: Figure 3

SECTION 2: FRAMING

E-5

MODEL

A B C D E F G H I J K L M

8” 35” 23.8” 24” 18” 36”

33.5” 34.7” 23.6” 7.8” 51” 36” 36”

This fireplace is a zero clearance design. No combustibles can be placed on the top surface

of the fireplace. Combustibles may be installed to the edge of the unit. Insulation and vapor

barrier should be placed a minimum of 2 inches from the unit. Build the framing according

to the specifications shown in the below table & figure 3.

Section 3: Recommended Power Supply Wire

Specifications

For 36EB110-GRT & 36EB111-GRC installations use three non-metallic

sheathed cables with ground wire for the power supply. Use the appropriate wires to

meet local and national electrical codes for rated power consumption.

For 36EB220-GRT & 36EB221-GRC installations use four non-metallic

sheathed cables with ground wire for the incoming power supply. Use the appropriate

wires to meet local and national electrical codes for rated power consumption.

Recommended Wire and Fusing Requirements

Use appropriate wire to meet local and national electrical codes for rated power

consumption. All wire gauges should be 12 gauge solid wires with a dedicated 15 amp

breaker for 120 volts. For 208/240 volts Builders Box models use two dedicated

15 amp breakers.

Allow at least 8 in of service cable for connecting power supply wire to junction box on

fireplace insert when installing before finishing wall. Allow up to 4 feet of service cable

for connecting power supply wire to junction box on fireplace insert after finishing wall.

The control box is supplied with a six meter long cable.

36EB110-GRT

36EB220-GRT

36EB111-GRC

36EB221-GRC

1 2 3 4 5 6 7 8 9 10 11 ... 46 47

No comments

Classic Flame 36EB110-GRT Instruction Manual Page 6