Classic Flame 36EB220-GRT Instruction Manual download pdf (Page 6)

E-5

Note: When a function is changed from the control

panel or remote control there will be a corresponding

indicator (see Figure 6) on the upper-right of the

projection screen. The indicator shows the function

changed and the level selected by the control panel or

remote control. When the function is turned off, the

corresponding indicator will flash 5 times and then

fade off.

TIMER

DOWN

LIGHTS

HEAT

LIGHTS

AUTO

TIMER

EMBERS

HEAT

FLAME

NOTE: PLEASE OPERATE REMOTE TRANSMITTER

AT A SLOW MEASURED PACE. PRESS THE

REMOTE CONTROL BUTTONS WITH AN EVEN

MOTION AND GENTLE PRESSURE. REPEATEDLY

PRESSING BUTTONS IN RAPID SUCCESSION

MAY CAUSE THE TRANSMITTER TO MALFUNCTION.

Figure 6: Remote Control

36EB111-GRC

36EB221-GRC

DISPOSAL OF USED BATTERIES

REPLACING THE REMOTE CONTROL BATTERY

When the remote control stops operating or its range seems

reduced, it is time to replace the battery with a new one.

1. The battery compartment is located on the back end of the

remote.

2. Press and slide the battery door open and remove

the old battery.

3. Insert a CR2032 battery， checking that the + and - sides

of the battery match inside the battery compartment.

4. Replace the battery compartment door.

36EB110-GRT

36EB220-GRT

Figure 7

on the upper-right of front projection screen

Battery may contain hazardous substances

which could endanger the environment

and human health.

This symbol marked on the battery

and/ or packaging indicates that used

battery shall not be treated as municipal

waste. Batteries should be disposed of

at an appropriate collection point for

recycling.

By ensuring the used batteries are disposed of correctly, you will help prevent potential

negative consequences for the environment and human health. The recycling of materials

will help to converse natural resources.

For more information about recycling of used batteries, please contact your local municipality waste

disposal service.

FLAME

COLOR

FLAME

LEVEL

As an important safety feature, the heating element is designed with a delayed activation sequence.

Therefore, when the heater is turned ON it will take several minutes for the unit to begin blowing hot air.

Subsequently, the fan blower will continue to run for several minutes after the heater is switched OFF.

If heater doesn’t work, but Power and Heater switches are in the “ON” position and thermostat is set

on “HI”, the product is on the protected status, then turn all switches to the “OFF” position and

unplug the unit from the wall outlet for 30 minutes. After 30 minutes plug the unit back into wall outlet,

and operate as normal.

1 2 3 4 5 6 7 8 9 10 11 ... 22 23

Comments to this Manuals

No comments

Classic Flame 36EB220-GRT Instruction Manual Page 6

Comments to this Manuals

Related products and manuals for Fireplaces Classic Flame 36EB220-GRT